Archives of Acoustics, 27, 3, pp. , 2002

Nonlinear effects and possible temperature increases in ultrasonic microscopy

J. Wójcik

J. Litniewski
Institute of Fundamental Technological Research, Polish Academy of Sciences

L. Filipczyński
Institute of Fundamental Technological Research, Polish Academy of Sciences

T. Kujawska
Institute of Fundamental Technological Research, Polish Academy of Sciences

Visualisation of living tissues or cells at a microscopic
resolution provides a foundation for many new medical and biological
applications. Propagation of waves in ultrasonic microscopy is a complex problem
due to finite amplitude distortions. Therefore, to describe it quantitatively, a
numerical model developed by the first author was applied. The scanning acoustic
microscope operating at 34 MHz was used with strongly focused ultrasonic pulses
of 4 periods. For measurements of signals, a 100 MHz PVDF probe was constructed.
Its frequency characteristic was found experimentally. The numerical calculation
procedure for nonlinear propagation was based on previous papers of the authors.
Computations have shown that in the case under consideration, only the spectrum
with an input lens pressure amplitude of 1 MPa was in agreement with the
experimental one. Based on transducer power measurements, a slightly smaller
pressure value was obtained thus confirming, to a good approximation, the
correctness of the applied methods. A significant parameter is the ratio of the
amplitudes of the second to the first calculated harmonics, which shows the
extent of the nonlinearity. In our case it was equal to 0.5. After averaging
over the surface of the finite electrode size used in measurements, this ratio
was reduced to 0.2. Pressure distributions in the lens cavity and the following
region in water were computed for the first 4 harmonics making it possible to
determine many features of the nonlinear propagation effects in the microscope.
Using the thermal conductivity equation and the rate of heat generation per unit
volume, determined for nonlinear propagation in water, a focal temperature
increase of 3.3o C was obtained. It was computed for a repetition frequency of
100 kHz. The computed temperature increases can be significant and also harmful,
especially when imaging small superficial structures and testing living cell
cultures. However, they can be easily decreased by reducing the repetition
frequency of the microscope. The developed numerical procedure can be applied
for much higher frequencies when living cells in culture are being investigated.
Full Text: PDF


Copyright © Polish Academy of Sciences & Institute of Fundamental Technological Research (IPPT PAN)